Johnson Systems JS-ICON Series Dimmer/Relay Rack (2410,2413,1220,1210/620) User Manual
Page 28
28
43. FW-LOAD
Load new firmware into the MADD-24 via the EEPROM memory module.
If a firmware update is required, Johnson Systems Inc. may supply an EEPROM
memory module with the latest firmware version. The firmware EEPROM memory
module can be inserted into PORT1 on the MADD-24 board and the firmware can be
loaded into the microcontroller.
Press EXECUTE to enter the menu.
DISABLED
This menu is disabled for inadvertent use. Proceed to enable.
ENABLED
Press and hold MENU (
) and MENU (
) at the same time for 4-5 seconds.
MEMCHECK
Automatically checks the EEPROM memory module for firmware type.
CRC-TEST
Automatically does a CRC test on the firmware code in the EEPROM.
>>>>>>>>
The CRC test in progress.
VER X.X
Displays the firmware version on the EEPROM memory module.
UPDATE??
Press EXECUTE to proceed.
SURE ???
Press EXECUTE to proceed.
UPDATING
Firmware update in progress.
WILL
Firmware update in progress.
AUTO
Firmware update in progress.
RESTART
Firmware update in progress.
PLEASE
Firmware update in progress.
WAIT....
When firmware update is complete the RUN LED flashes and system restarts.
NO MEM!
Displayed if an EEPROM memory module is not detected.
WRONG
Displayed if the wrong type (parameter) of EEPROM memory module detected.
MEM TYPE
Displayed if the wrong type (parameter) of EEPROM memory module detected.
WRONG
Displayed if the wrong product type of EEPROM memory module detected.
PRODUCT
Displayed if the wrong product type of EEPROM memory module detected.
CRC ERR!
Displayed if the CRC test fails and the EEPROM memory module is defective.
WARNING: Do not reset or turn the power off while the firmware is being updated.
Doing so will cause unrecoverable loss of firmware data that is being loaded into the
MADD-24 microcontroller.
44. RESTORE
Restore parameters saved in the EEPROM memory module.
All of the configuration setting parameters can be restored from the EEPROM
memory module if they have been inadvertently changed or corrupted. This feature
can also be used to load configuration setting parameters into a different or new
control module. This reduces the configuration time for multi-system applications that
require similar settings or when a replacement control module is required.
Press EXECUTE to enter the menu.
DISABLED
This menu is disabled for inadvertent use. Proceed to enable.
ENABLED
Press and hold MENU (
) and MENU (
) at the same time for 4-5 seconds.
MEMCHECK
Automatically checks the EEPROM memory module for parameter type.
OKAY....
The EEPROM memory module has been verified for parameter type.
PROCEED?
Press EXECUTE to proceed.
SURE ???
Press EXECUTE to proceed.
CRC-TEST
Automatically does a CRC test on the parameter code in the EEPROM.
WAIT
CRC test in progress.
VERIFY
CRC test in progress.
DONE!!
CRC test is done and the parameter restore automatically begins.
WILL
Parameter restore in progress.
AUTO
Parameter restore in progress.