Johnson Systems CS-IPRO Wireless Hand-Held Programmer for CS-DMX Series - Manual (Page 7)

www.johnsonsystems.com 7
Detailed Programming
of System Configuration Menu Items
The sequence of the following system configuration menu items appear as the MENU DOWN ( )
switch is pressed. Pressing the MENU UP ( ) switch will sequence the system configuration
menu items in the opposite order. Pressing and holding either of the MENU UP/DOWN ( )
switches will speed up the scroll rate, which can be helpful to speed up the configuration time.
1. CHECK Check the DMX channel patch for each of the sliders
PATCH Checks the patch saved in the CS-IPRO memory only.
Provides a quick way to check the DMX channel (001 to 512) patch for each of the
sliders (01 to 12) saved in the CS-IPRO memory.
Press EXECUTE to enter the menu.
SS CH# Indicates the selected slider (SS) and DMX channels (CH#) patched.
01< ??? Indicates slider 01 is not patched (???) to any DMX channel(s).
12< 012 Press MENU ( ) to select the slider number from 01 to 12 to check.
12< 512 Press EXECUTE to toggle through all of the DMX channels patched to the slider.
Press ESCAPE to exit the menu.
2. EDIT Edit the patch and assign DMX channel(s) to each of the sliders.
PATCH Edits the patch saved in the CS-IPRO memory only.
Each of the sliders on a CS-DMX control station can be assigned to control any
combination of DMX channels from 1 to 512. The patch is saved in the CS-IPRO
memory.
Press EXECUTE to enter the menu.
SS CH# P Indicates the selected slider (SS), DMX channel (CH#) and patch (P) status.
01<000 ? The pointer (<) indicates the selected slider to be edited.
12<000 ? Press MENU ( ) to select the slider number from 01 to 12.
12 000 ? Press EXECUTE to edit the DMX channel(s) to patch to the selected slider.
12 000 ? Press EXECUTE to move the cursor to the right, under the digit to be edited.
12 000 ? Press ESCAPE to move the cursor to the left or to exit the menu.
12 512 Press MENU ( ) to select the DMX channel from 001 to 512.
12 512 Press EXECUTE to move the cursor to the right, into the patch (P) position.
12 512 * Press EXECUTE to patch (*) the selected DMX channel to the selected slider.
12 512 Press EXECUTE to toggle the patch status asterisk (*) on and off.
12 512 * Repeat the previous 8 steps until the DMX channel patch is complete.
12<512 * Press ESCAPE to exit the menu and save the DMX channel patch.
The menu will automatically timeout after 2 minutes of inactivity and save.
3. CLEAR Clear the DMX channel patch for a selected slider or all sliders.
PATCH Clears the patch saved in the CS-IPRO memory only.
Provides a quick way to clear the DMX channel patch for a selected slider (01 to 12),
or all (ALL) sliders can be cleared at the same time. The revised patch is saved in the
CS-IPRO memory.
CLEAR Press EXECUTE to enter the menu.
SS>01 Indicates the selected slider (SS) to clear.
SS>ALL Press MENU ( ) to select the slider number from 01 to 12 or ALL to clear.
SURE ??? Press EXECUTE to clear the selected slider(s). Are you sure?
DONE !!! Press EXECUTE again to clear the selected slider(s).
Press ESCAPE to exit the menu.