JULABO SW23 Shaking Water Baths - Manual (Page 31)

Shaking Water Baths
31
8.7. Evaluation of the temperature limits
The high- and low-temperature limit can be adjusted in two ways
(see page 22)
3. As pure warning function with an acoustic warning signal in
regular intervals.
Adjustment „Li 0“ – factory adjustment
4. As temperature limit by switching-off the heating. Adustment „Li
1“
The alarm is indicated by optical and audible signals
(continuous tone) and on the MULTI-DISPLAY (LED) appears
the error message "Error 01".
1. Press and at the same time.
2. Use the cursor keys to select the menu option
Limit. (example: „Li 0“).
3. Select the alternative state with the edit keys and
confirm the selection with the ENTER key (display „Li 1“).
4. Press and at the same time.
9. Safety installation (with shutdown function)


(excess temperature protection)
These safety installations is independent of the control circuit.
When the temperature of the bath liquid has reached the safety
temperature, a complete shutdown of the heater and pump (only
CW-models) is effected.
The alarm is indicated by optical and audible signals (continuous
tone) and on the MULTI-DISPLAY (LED) appears the error
message "Error 01".