The Helman Group 1769 WEIGH SCALE MODULE HM1525 - Manual (Page 11)

Chapter
1
Hardware
Overview The Weigh Scale module can be attached to the controller or to an
adjacent I/O module before or after din rail mounting. It is a Class 1
module (uses eight input words and eight output words). It interfaces to
strain gage based transducers (350ohm or 700ohm).
The module can accept input from two sensors. The module has no
output channels. Module configuration requires manual and user
programmable setup.
The Weigh Scale module receives and stores digitally converted analog
data into its image table for retrieval by processor. The module supports
connections from any combination of up to two strain gage sensors.
Any combination of Helm Strain Gage sensors can be used. Contact
Helm for additional information on the type and application of different
sensor options.
Page 1-2