2 display after switch-on, Display after switch-on, 5 commissioning the instrument – JUMO 14597 safetyM TB/TW - Temperature Limiter and Temperature Monitor Operating Manual User Manual
Page 17
5 Commissioning the instrument
15
5.2
Display after switch-on
v
The value to be displayed is adjustable, as in Chapter 7.6 “C116 Display after switch-on”
5.3
Selecting and editing parameters (plausibility requirement for input values)
Values are displayed in the normal display.
h
To edit a value, here, for example, the AL limit, perform steps 1 - 4
1
Press
for longer than 2 secs
1st value in the parameter level appears
2
Use
to increase
or
to reduce
AL flashes
3
Press
briefly
Limit flashes for checking, both at top and bottom of
display
4
Briefly press
to confirm.
The value is stored.
Use
+
to return to normal display or
return automatically after a timeout
H
At parameter level, if no key is pressed, the instrument automatically
returns to normal display after 30 seconds (timeout) and the value is not stored.
v
see overview of operation on the first inside page of this manual