KD Scientific Legato 200 Series - Manual (Page 25)

25
Configuring the KDS Legato 200 Series
K
D
S
L
e
g
a
to
2
0
0
S
e
ri
e
s
U
s
e
r’s
M
a
n
u
a
l
KD Scientific Legato 200 Series Syringe Pump User’s Manual
Publication 5617-002-Rev F
Setting the Force Limits
The maximum linear force of the syringe pump is 75 lbs
or 35 kgs. This force is sufficient to damage delicate, low
volume syringes, as well as many standard syringes if
pumping viscous fluids. The % of maximum force applied
by the pusher block can be changed.
In the set up screen, press Force .
Set the force level.
Press Other Value to enter a custom force %
Accept the changes made by pressing
and go back to the Set Force screen.
Cancel the changes made by pressing
and go back to the Set Force screen.
For a Custom Force %
Enter the precentage for custom force %
Accept the changes made by pressing
and go back to the Set Force screen.
Cancel the changes made by pressing
and go back to the Set Force screen.
✐
NOTE: A minimum value of approximately
30% is required to overcome friction forces
in the mechanism. You may have to set the
force level to a higher value depending on
the backpressure/friction in your system.
Press Here
Press here to enter
custom force %
phone
508.429.6809
fax
508.893.0160
e-mail
[email protected]
web
www.kdscientific.com
Suggested Force Level Settings for Common Syringes
Syringe Type/Material Capacity Force Setting Common Manufacturer(s)
Plastic Syringes
≤20ml 50%
BD plastic, Sherwood,
Airtite, Terumo
>20ml 100%
Stainless Steel All 100% KDS, Cole-Parmer
Glass/Glass
≤20ml 20%
KDS Glass, Cadence (Popper)
>20ml 30%
Glass/Plastic
≤1000µl 30%
Hamilton, SGE ≤5ml 50%
>5ml 100%