KD Scientific Legato 200 Series - Manual (Page 77)

77
Appendices
K
D
S
L
e
g
a
to
2
0
0
S
e
ri
e
s
U
s
e
r’s
M
a
n
u
a
l
4
6
2
8
3
11
7
9
1
5
1. Release Tabs
2. Pusher Block
3. Retaining Bracket
(Pusher Block)
10
4. Bracket Clamping Knob
5. Thumbscrew Cap
6. Screw Cap
7. Retaining Bracket
(Syringe Holder)
8. Syringe Holder
9. T-Knob
10. Bumper
11. Clamp Bar Assembly
Syringe Loading – Micro Liter Multi-Rack
1. Squeeze Release Tabs (1) and adjust the Pusher
Block (2) to the approximate length of the
syringe(s).
2. Loosen the Retaining Bracket (3) on the Pusher
Block (2) by unscrewing the Bracket Clamping
Knobs (4).
3. Loosen the Retaining Bracket (7) on the Syringe
Holder (8) by unscrewing the two T-Knobs (9).
4. Create room for the syringe(s) by unscrewing the
Screw Caps (6) until the Bumpers (10) are at their
maximum height.
5. Slide the syringe under the Bumper (10) placing
the barrel flange within the Syringe Holder’s
Retaining Bracket (7) and the plunger flange within
the Pusher Block’s Retaining Bracket (3).
6. Lower the bumpers (10) until they are firm against
the syringe(s) by screwing in the Screw Cap (6).
7. Push the Syringe Holder’s Retaining Bracket (7)
tight against the barrel flange and tighten into
place using the T-knobs (9). Then push the Pusher
Block’s Retaining Bracket (3) tight against the
plunger flange and tighten using the Bracket
Clamping Knob (4).
Front view of KDS Legato 200 Series showing controls for micro liter multi-rack syringe loading
✐
NOTE: If you are using syringes larger than
1 ml it may be easier to unscrew one of the
Thumbscrew Caps (5) and swing the
Clamp Bar Assembly (11) to the side,
making more room to load the syringe(s).
After the syringe(s) are in place swing the
Clamp Bar back over the Syringe Holder
(8) and reattach the Thumbscrew Cap (5).
✐
NOTE: Mechanical stops are set using the
same steps as a standard 2 syringe holder.
phone
508.429.6809
fax
508.893.0160
e-mail
[email protected]
web
www.kdscientific.com
Micro Liter Multi-Rack Configuration
KD Scientific Legato 200 Series Syringe Pump User’s Manual
Publication 5607-001-Rev F