Koolance KIT-1050SL - Manual

The EHX-1050 is designed to maximize compatibility with different computer chassis. It requires two side panel screws on the
rear of the computer chassis.
Koolance EHX-1050 Installation Guide
v1.00
L-Bracket Slot
Interface
Bracket
Screws
EHX to Pole
Brackets
Pole to Chassis
Brackets
EHX to Chassis
Brackets
L-Bracket
Shut-off Valves
Main Mounting Pole
Pole Extension 1 Pole Extension 2
1
Bracket
Mounting Holes
Start the installation by mounting the EHX to Pole brackets to the
EHX-1050 unit with the included screws. These can be adjusted later
if necessary. Slide the Main Mounting Pole through both of these
brackets (after removing the pole’s threaded metal end caps).
Next, thread both Pole to Chassis brackets onto either end of the Main
Mounting Pole. Typically, the sliding chassis tabs will face toward the outside
of the chassis, but some systems may require them to face inward.
Chassis Tab
The assembly thus far should look similar to the image on
the left.
There is no “correct” position for the brackets on the
Main Mounting Pole and EHX-1050. Simply, they should
be adjusted so that the Pole to Chassis brackets will align
with at least two of the computer’s side panel screws.
The EHX should be mounted behind the computer side panel that is least often
removed. It can be mounted to hinge open from the left or right, provided there are
screws behind the computer to do so.
It is recommended to mount the EHX with radiator nozzles on the top side for easier
hose routing (see image to the right).
There are rows of screw holes on both
sides of the EHX-1050 housing for vertical
adjustment of the mounting brackets.