Labnet Z400K High Capacity Centrifuge - Manual (Page 11)

Z 400 K / March 1997 11 E
4.4 Preselection of speed / RCF
You can preset the speed between 250 rpm amd 13500 rpm and RCF-value
between 500 and 18000 x g.
3 1 2 6 4 5 figure 6
When the centrifuge lid is open, you can preset the required speed or rcf with the
knob(2).
If the centrifuge lid is closed and during the run, the speed can be changed as
follows:
Press key "preset" (1), hold it and at the same time change speed with the knob
(2).
The preselected speed will be indicated in the speed display (3).
With the key "speed/rcf" (6) you can change indication from speed to rcf-value.
The two green control lamps (4 or 5) show which mode is active.
The centrifuge will accelerate only to the max. allowed speed of the inserted rotor.
The allowed max. speed for all rotors please see table under.
Z 400 K Z 400 K Z 400 K Z 400 K Z 400 K
Rotor max. Speed Rotor max. Speed
220.27 V02 4 000 rpm* 220.92 V01 13 000 rpm
220.59 V06 13 500 rpm 220.93 V01 3 500 rpm
220.50 V05 3 500 rpm 220.81 V05 3 500 rpm
220.86 V01 3 500 rpm 220.96 V02 6 000 rpm
220.88 V01 13 500 rpm 220.97 V02 6 000 rpm
220.89 V06 12 000 rpm 221.02 V01 3 500 rpm
221.03 V01 3 500 rpm
*with rectangular bucket 610.015 only 3500 rpm