Landoll MCCS2253 18,9 RIGID PULVI-MULCHER - Manual (Page 11)

2-1
Chapter 2
Assembly

CAUTION
The intent of this chapter is to provide instruction,
allowing you to safely and correctly assemble your
Brillion product.
NOTE
“Left” and “Right” refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
Frame Assembly
1. Place Front and Rear Frame Tubes on supports
spaced 10’ apart. Ensure supports are rated at
2000lbs each.
2. Place Rockshaft between Front and Rear Frame
Tubes.
3. Position Inner Frame Tubes. Fasten Inner Frame
Tubes to Front and Rear Tubes with 3/4”-10 X 2”
Capscrews, Lock Washers and Nuts. Ensure that the
inner frame tubes are square with the front and rear
frame tubes. See Figure 2-1.
4. Position Outer Frame Tubes. Fasten with 5/8”
U-bolts, Lock Washers and Nuts. See Figure 2-1.
5. Tighten all hardware to the recommended torques.
See Page 4-1.
Figure 2-1: Frame
Do not work on or under this machine unless
securely
blocked and supported by a hoist or
tractor or by other sufficient means.
Capscrew,
3/4-10 X 2
Lock Washer, 3/4-10
Hex Nut, 3/4-10
U-Bolt,
5/8-11 X 5 ½ X 6 11/16
Washer, 5/8
Hex Nut, 5/8-11
Relief Valve
Mounting Bkt.
51 ½”
51 ½”
43 3/8”