Landoll MCCS2253 18,9 RIGID PULVI-MULCHER - Manual (Page 35)

3-1
Chapter 3
Operation
NOTE
This chapter will cover the basic operation and
procedures for the Landoll Brillion Pulvi-Mulcher. Be sure
to read and understand the Safety Procedures and
Cautions starting on page 1-1.
Level Adjustment
To adjust the front of the machine higher during transport,
add spacers between the bumper and drawbar vertical
tube.
Figure 3-1: Spring Adjustment
Spring Adjustment
The Springs are used to cause the rear of the machine to
lift before the front during the raising cycle. (this prevents
jolts when it shifts from rear-heavy to front-heavy).
Tighten springs only to the level to accomplish this.
Transport Lock
To prepare the machine for transport, raise it fully and
install pin with sleeves shown. See Figure 3-1. The rear
most hole is used for pin storage during field operations.
Transport Lock Pin
Spring Adjustment
Depth Control Pin
Spacers
Transport Lock
Pin Storage
Important: Transport Lock Pin is placed
in this position only when the Hydraulic
Cylinder is fully extended.
Failure to follow this procedure will
result in RockShaft or Hydraulic Cylinder
damage.