Landoll MCCS2253 18,9 RIGID PULVI-MULCHER - Manual (Page 41)

PREVENTATIVE MAINTENANCE
4-3
Tires
Recommended inflation pressure for the 9.5L x 15 6 Ply
tire is 30-32 PSI.
Figure 4-1 Wheel Hub
Lubrication
Lubricate bearings with quality grease per recommended
lubrication frequency intervals indicated or if machine is
not used for an extended period. Greaseable
components are the same on each side.
Lubricating Wheel Hub:
Grease Wheel Hubs every 40-60 hours.
Repack Wheel Hub bearings annually before each
season usage. See Figure 4-1.

CAUTION
Storage
At the end of the season clean your machine for storage.
Avoid spraying high pressure washer directly at bearing
seals. Grease machine after washing to displace any
residual water. Repaint areas where paint has worn off.
Repair or replace any broken or damaged parts. Store in
a dry, protected place.
Fasteners
Before operating your Brillion machine, check all
hardware for tightness. Use the Tightening Torque Table
above as a guide.
After a few hours of use, check entire machine and
tighten any loose nuts or bolts. Daily or periodic checks
should be made thereafter.
When replacing bolts, be sure to use fasteners of equal
grade.
Over lubrication of these bearings can cause
premature bearing failure.