Landoll MCCS2253 18,9 RIGID PULVI-MULCHER - Manual (Page 36)

3-2 1K965
OPERATION
Depth Control
Maximum operating depth of six (6) inches is obtained
with depth pin in front hole. Each subsequent hole
reduces the depth approximately one (1) inch. See
Figure 3-1.
In addition to the five depth settings, you have one other
option; by using the optional hole setting you can achieve
a working range of approximately 4” maximum down to
“zero or completely inactive teeth.”
Figure 3-2: Depth Control

CAUTION
Wheel Adjustment
Allow just enough looseness so each wheel will turn by
itself. If the wheels become worn, loosen the axle clamp
at the end of each roller and tighten as needed.
Hydraulic Cylinder
The hydraulic cylinder must have pin centers of 31 1/2”
retracted and 47 1/2” extended. Longer centers will
cause improper operation and possible machine
damage.
Land Leveler - Optional
Adjust the leveler to the highest position that does the
required job. Its purpose is to break up and scatter any
large lumps that are above the normal ground level. If the
soil pushes ahead of the bar, its set too low. Striking large
rocks will damage the leveler bar and possibly other parts
of the machine.
V Leveler - Optional
Adjust the V Leveler to the highest position that does the
required job. Its purpose is to break up and displace any
large lumps that are above the normal ground level with
minimal planing. Striking large rocks will damage the
leveler bar and possibly other parts of the machine.
Normal Hookup
Optional setting for
shallow working or non-
working spring teeth.
(Approx. 4” max. depth)
Do not attempt to remove the pin connecting the
cylinder to the rockshaft if there is any load on
the cylinder. The machine will fall and may cause
injury.