MAMAC Systems IP-PC-101-44-VDC - Manual (Page 16)

SECTION 3 - Network Configuration Options
3.0.0
© Copyright 2008 DN IS-IPPC101.1 ® Registered trademark MAMAC SYSTEMS, Inc.
15 of 20
Router
Ethernet Hub Router
Bridge Router Wireless Router
Configuration 1
Configuration 2
Configuration 3
IP Sensor
Appliance
IP Sensor
Appliance
IP Sensor
Appliance
Cat 5 Patchcord Cable
Cat 5 Patchcord Cable
Cat 5 Patchcord Cable
Static IP Address: After the initial configuration, power down the appliance by unplugging the
power terminal block and disconnect the crossover cable.
CAUTION: Each time the static IP is
changed, power cycle the appliance to load up the new static IP. Connect the Maverick to the
ethernet as shown in fig. 7. Three options are available-- 1) Use a CAT 5 patchcord and plug it into
a hub or switch and connect the hub/switch to a router on the web. 2) Use a CAT 5 cable to
connect directly to the router. 3) Configure an Ethernet Bridge and router and connect the
appliance to the Bridge with a CAT 5 cable. For more information on wireless 802.11 B/G
configuration, please refer to TI IP802.11.
Terminate the sensors and outputs as shown in fig. 3 (Section 1.4.1). Power up the appliance. To
connect to the appliance, launch a web browser (Internet Explorer or Firefox) on a laptop/PC, PDA
or web enabled mobile/cell phone. Delete all text in the browser address bar and punch in the static
IP address and hit enter. The Maverick will connect and the Main page will launch. Have fun!
Figure 7