MAMAC Systems IP-PC-101-44-VDC - Manual (Page 8)

SECTION 2 - Initial Configuration
Figures 5A and 5B
IP Sensor
Appliance
Ethernet Hub Laptop/PC
Configuration 2
Cat 5 Patchcord Cable
Laptop/PC
Configuration 1
Cat 5 Crossover Cable
IP Sensor
Appliance
Figure 5B
Figure 5A
For first time start-up, a laptop/PC and a crossover cable is required. If a crossover cable is not
available, a hub can also be used as shown in fig. 5B. Terminate the appliance as shown in fig. 3.
Unplug the input and output terminal blocks and leave only the power terminal block plugged in.
Attach the crossover cable to the appliance and the other end to the laptop ethernet jack as shown in
fig. 5A. If using a hub, attach a CAT 5 patchcord between the appliance and the hub and another CAT
5 patchcord between the hub and laptop as shown in fig. 5B.
Turn the power on. The power LED will come on. After 10 seconds the heartbeat LED will start
blinking at one pulse per second rate. The link LED should light up if the appliance is correctly
connected to the laptop/PC.
© Copyright 2008 DN IS-IPPC101.1 ® Registered trademark MAMAC SYSTEMS, Inc.
7 of 20
2.0.0