MAMAC Systems IP-PC-101-44-VDC - Manual (Page 19)

SECTION 3 - Manual Control
3.1.1
© Copyright 2008 DN IS-IPPC101.1 ® Registered trademark MAMAC SYSTEMS, Inc.
18 of 20
Manual Control:
Any output can be controlled manually from the web browser by clicking on the
Manual Control
icon on the navigation bar. A new page will be served up showing the current
output control status and state. Suppose the user desires to turn output #1 on manually. Click the
Manual
radio button for
Output #1 and click Save
. The status will change from
Automatic
to
Manual
. Now click the
On
radio button for
Output #1 and hit Save
. The Output #1 state will
change from
Off to On. Now navigate to the Main
page and the output will be
On and the Manual
Control Status will show output #1 in manual state.
To turn the output back to automatic, click
Manual Control
on the navigation bar, change the
state to
Off
and click
Save
. Again click the
Automatic
radio button and hit
Save
. Output is back
under automatic control.
CAUTION: In case of power failure, all outputs under manual
control will revert back to automatic control when power is restored.
Save
13.34:59 May 9, 2008
IP Sensor Appliance:
Main
Manual Control
Data Logging
Configuration
MAMAC UNO
Configuration | Password/Clock
Copyright 2008 c www.mamacsys.com
R Registered trademark MAMAC Systems, Inc.
MANUAL CONTROL
Current Status Output Status
Directions:
1. Auto
Auto
Auto
Auto
Manual
Manual
Manual
Manual Automatic
Manual
Automatic
Automatic
Off
Off
Off
Off On
On
On
On
Off
Off
Off
On
2.
3.
4.
1. Change the ‘Output Status’ to ‘Manual’, click ‘Save’..
Set the ‘Control’ to the desired setting (On or Off), click ‘Save’.
The ‘Current Status’ will switch to desired state.
Follow steps 1 and 2 to change back to ‘Automatic’. 2.
3.
4.