Memmert INB 200 - 500 Incubators (Generation 2003) - Manual (Page 13)

BASIC page 13
8 Timer operation
In this operating mode the oven operates on the timer; it heats/controls to the set temperature and maintains
this temperature until the set time has elapsed. The clock symbol is flashing during timer operation, then
the heating is switched off; on UFB/SFB ovens the fan runs on for 30 minutes. The timer display shows END.
- The time can always be set to OFF, the heating is then switched off and the timer display shows END.
- Time is counted down, it is always possible to see how long the oven will remain switched on.
Setting the temperature:
Turn the push/turn control clockwise until the temperature display is flashing.
Hold down the SET key and set the required temperature setpoint with the push/turn control.
After the SET key has been released the oven flashes briefly the temperature setpoint. The display then
changes to the actual temperature and the controller starts to control to the selected temperature
setpoint.
Setting the timer:
Turn the push/turn control anticlockwise until the timer display is flashing.
Hold down the SET key and set the required operating time with the push/turn control.
˚C
h
Example: the oven heats and controls at 180°C for 45 minute duration.
(time is counted backwards)