MotorGuide Digital Remote DRC - Manual (Page 4)

3
M887655
each time one of the arrow buttons is pressed.
Each button press steers the motor left or
right one step. Holding a button down will
rapidly steer the motor until it reaches a stop;
once it has reached a stop, the receiver will
no longer beep when you press the button.
When the motor is first powered-up, it
automatically steers to a center position
unless a foot-pedal is used, then it will steer
to the position of the pedal.
2. Speed: Use the + and – buttons to control
the speed of the motor, a beep will sound
each time the + or – buttons are pushed.
Holding the button down will rapidly speed-
up or slow-down the motor until it reaches
minimum or maximum speed; once at the
limit, the receiver will no longer beep when
you press a button.
When the motor is first powered-up, the
initial speed is set to the same setting as on
the foot-pedal speed wheel. If a foot-pedal is