Purenex Multipure Aquaperform For Model MP880SB - Manual (Page 17)

Congratulations, your Drinking Water System has been connected to your plumbing and you are now ready to
start-up the unit, as follows:
1. Using a paper towel or cloth, dry off all plumbing connections.
2. Also, dry off the drinking water unit.
3. Ensure that all connections are tight (CAUTION: DO NOT OVERTIGHTEN).
4. You are now ready to turn your water supply back on; turn on the plumbing angle stop
valve under your sink or the water shut-off valve where water enters your residence.
5. Turn on the water going to your drinking water system by turning the handle on the shut-off
Valve that you installed (see Section III).
6. Open the drinking water faucet by turning the handle on the faucet.
7. Allow water to run through the unit for about 10 minutes so that all air can escape.
8. Adjust the handle on the shut-off valve so that the water flow to the drinking water faucet does not exceed the flow rate
(1.0 gpm; to measure flow rate - it takes approximately 20 seconds to fill a quart at 1.0 gallons per minute)
9. Close the drinking water faucet and check for leaks.
a. Check the V-band to confirm that it is secured evenly around the housing top and bottom.
b. Hand-tighten the black knob on the V-band until it is as tight as possible.
10. Allow water to run through the unit to waste for approximately 20 minutes to flush the filter of loose carbon fines.
Note: units with the capacity monitor please disconnect the monitor before flushing the filter. The carbon fines will clog the
measuring device. Once you have flushed your filter, reconnect the monitor.
11. Shut off the water and check for leaks.
Your Drinking Water System is now ready for use. You can enjoy having great tasting, high quality water for drinking, cook-
ing, beverages, food preparation, etc. whenever you want it.
Congratulations, you have completed the installation.
For optimum performance and to maintain the warranty on your Multi-Pure Drinking Water System, it is recommended that
your filter be replaced on a regular basis Filter life will vary depending on amount of water used and the type and level of
contaminants in your local water.
If you have any questions regarding the installation of your
Multi-Pure Drinking Water System, call:
Multi-Pure Corporation
Customer Relations Department
7251 Cathedral Rock Drive
Las Vegas, NV 89128
(702) 360-8880 phone
(800) 622-9206 toll-free
(702) 360-8575 fax
email: [email protected]
www.multipure.com
17
VIII. START-UP AND USE OF YOUR MULTI-PURE DRINKING WATER SYSTEM