Purenex Multipure Aquaperform For Model MP880SB - Manual (Page 5)

The Models MP880SB, MP880SI, and MP880EL Drinking Water Systems are designed for use below the sink and can
easily be installed on the incoming cold water line. The MP880SB and MP880EL units are connected to a specially
designed stainless steel faucet (spigot) which installs directly on your sink, requiring little space. Your Below Sink Unit is
shipped with only one installation kit consisting of the accessories and fittings deemed appropriate for your area. Alternate
accessories may be purchased at a minimal cost.
The Multi-Pure Model MP880SI includes the housing, filter, and adapters; no installation fixtures or accessories are provid-
ed. MP880SI is appropriate for an in-line installation and can be used with your existing faucet. It is recommended that
the inline model be installed by a professional plumber in accordance with established plumbing procedures.
Model MP880SB
Required Tool List
The following tools are required to install your below sink Multi-Pure
Drinking Water System:
Installation of Faucet/Spigot (Ceramic/Porcelain Sink):
- 3/8" Reversible Electric Drill
- 7/16" (or 1/2”) high speed steel drill bit
- ½" carbide tipped masonry drill bit
- Hammer
- Center punch
- 8" adjustable wrench
- Pliers or Vise Grips
Installation of Faucet/Spigot (Stainless Steel Sink):
- all of the above (except masonry drill bit), plus…..
- 1/8” high speed drill bit
Adapta Valve Installation:
- 8" adjustable wrench
- Wire Cutter or Knife
Installation of MP880EL Capacity Monitor:
- (see tool list in Section II.C)
5
I.C. Below the Sink Installations