Purenex Multipure Aquaperform For Model MP880SB - Manual (Page 8)

8
II.C. Installing the Faucet with a Capacity Monitor
1 spout
2 faucet handle
3 faucet base
4 faucet stud
5 tubing (blue) attached to faucet
6 smaller rubber washer
7 capacity indicator plate (black)
8 black wire (attached to #7)
9 larger rubber washer
10 hard black washer with side cut
11 track washer
12 lock washer
13 wing nut
14 capacity flow device
15 filter monitor box
16 adapters
(MC745), two
17 tubing from capacity flow device
to housing outlet
Capacity
Monitor
Assembly
Faucets with Capacity
Monitor include:
Mounting the Faucet with a Capacity Monitor:
1. Follow the preceding instructions for drilling the hole; however, use the 1/2”
drill bit all the way through the sink instead of the 7/16” drill bit to allow room to
feed the faucet stud and the monitor cable down through the hole in the sink.
2. Note that the blue tubing is attached to the faucet.
3. From the sink / counter top, place over the faucet hole:
a. The larger soft black rubber washer (#9).
b. Then the Capacity Indicator Plate (#7); feed the attached black cable (#8)
through the hole in the sink / counter. Position the Capacity Indicator Plate
so that the indicator light will be easy to see.
c. Place the smaller soft black rubber washer (#6) over the Capacity Indicator
Plate.
d. Place the faucet base (#3) on the soft washer and Capacity Indicator Plate,
feeding the faucet stud and blue tubing down through the hole in the sink /
counter. The faucet stud will now be accessible from below the sink.
4. From under the sink, do the following:
a. Slide the black plastic hard washer (#10) (with the small side up) over the
blue tubing (#5), black wire (#6) and faucet stud (#4).
b. Slide the black "track" washer (#11) over the threaded faucet stud with
the flat side down. Guide the black wire (#8) through the "track" to assure
that the wire will be protected in the track and not be pinched between the
sink /counter and the stud nut.
c. Slide the lock washer (#12) on the faucet stud.
d. Screw on the stud wing nut (#13), hand-tightening it just enough to keep
the faucet secure on the sink top.
Countertop
tubing from
faucet
tubing from
housing
Filter Monitor Box
Capacity Flow Device
black wire from capacity
indicator plate
Installation Overview
4
5
7
8
9
10
11
12
13
countertop
countertop
1
2
3
6
14
15
5
16 16 17
Your Multi-Pure Drinking Water System is equipped with a DigiFlow 5100V Capacity Monitor that flashes red when the
filter should be changed. Models with capacity monitors are equipped with a chrome-plated designer faucet with the tubing
attached. In addition you will receive the DigiFlow 5100V Capacity Monitor (consists of two pieces), two adapters, and addi-
tional tubing (see diagram and parts list below). Not included but required for installation are two AAA batteries.