Multiquip LS-60TD - Manual (Page 20)

PAGE 20 — MAYCO LS-60TD PUMP — OPERATION AND PARTS MANUAL — REV. #4 (09/15/11)
Figure 6 illustrates the location of the major components for
the LS-60TD Structural Concrete Pump. The function of each
component is described below:
1. Tow Hitch Coupler – Requires a 2-inch ball hitch or a
3-inch pintle. Capable of towing 6,000 lbs.
2. Documentation Box – Contains engine and pump
operation, parts and maintenance information.
3. Manifold Access Door– Turn handle and lift door to
access the Hydraulic Manifold Block.
4. Hydraulic Manifold Block – Aluminum block that
controls the flow of hydraulic pressure to the
components required to control the pump.
5. Hopper Discharge Sleeve – Connect hoses or steel
pipes to the discharge sleeve for pouring concrete.
6. Pump End Jack Stand – Use this jack stand to level
and support the rear end of the pump. NEVER deploy
on un-level ground and always check for firmness of
ground.
7. Shuttle Cylinder – Under pressure, the shuttle cylinder
shears concrete passing from the concrete cylinder to
the delivery line durring the cycle phase.
LS-60TD PUMP — PUMP COMPONENTS
Figure 6. Major Pump Components