Components – Multiquip LT12DAB User Manual

Page 16

Advertising
background image

page 16 — LT12Dab LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #0 (06/03/11)

COMpOnentS

Figure 3. Major Components (Control Panel Side)

8

6

11

10

12

14

15

16

17

1

2

4

5

7

9

3

13

18

18

Figures 3 and 4 show the location of the controls and

components for the LT12DAB light tower. The function of

each control is described below.
1.

mast Rotation Locking Knob — Unscrew this knob

to release mast for rotation. Tighten this knob to lock

mast after it is set to the desired position.

2.

mast extension Winch — Use this winch to extend

the mast to the desired height. Maximum height is

approximately 31.5 feet (9.6 meters).

3.

mast Rotation Handles — Grip these handles to rotate

mast to desired position.

4.

Lifting bale — Light tower can be lifted using this lifting

bale. The lifting bale is balanced for a fully configured

light tower. Removal of any components will unbalance

the lifting bale.

5.

Forklift pockets — Light tower can be lifted using

these forklift pockets. Insert the forks of the forklift as

far possible into the pockets.

6.

mast Cradle Support — When towing of the light

tower is required, place the tower mast into the cradle

support. Make sure cradle lock/release pin has been

inserted and mast is locked.

7.

T-bar — Allows the lamps to be mounted vertically or

horizontally.

8.

Lamps — Four 1000-watt metal-halide bulbs with

a 110,000 lumens capacity each. Light coverage is

typically between 5 to 7 acres.

9.

Cradle Lock/Release pin — Locks mast in cradle

support and releases mast when removed.

10.

Rear Jackstands — There are two jackstands located

at the rear of the trailer. Use these jackstands to level

and support the light tower.

11.

Chock blocks — Place these blocks (not included

as part of the light tower package) under each trailer

wheel to prevent rolling.

12.

Outrigger Jacks — Use these 2 outrigger jacks to

level and support the light tower. For more stability, the

outriggers can be deployed.

13.

Tongue Jackstand — Use this jackstand to support

the tongue when attaching the light tower to a towing

vehicle.

Advertising