Inspection, Before starting, Indoor installation – Multiquip LT12DAB User Manual

Page 20: Engine oil check, Fuel check

Advertising
background image

page 20 — LT12Dab LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #0 (06/03/11)

inSpeCtiOn

beFORe STaRTIng

1. Read all safety instructions at the beginning of

manual.

2. Clean the light tower, removing dirt and dust, particularly

the engine cooling air inlet and air cleaner.

3. Check the air filter for dirt and dust. If air filter is dirty,

replace air filter with a new one as required.

4. Check all fastening nuts and bolts for tightness.

InDOOR InSTaLLaTIOn

Exhaust gases from diesel engines are extremely

poisonous. Whenever an engine is installed indoors the

exhaust fumes must be vented to the outside. The engine

should be installed at least two feet from any outside wall.

Using an exhaust pipe which is too long or too small can

cause excessive back pressure which will cause the engine

to heat excessively and possibly burn the valves.
Eliminate the danger of deadly carbon monoxide gas.

Remember that exhaust fumes from any gasoline or

diesel engine are very poisonous if discharged in a closed

area. If the light tower is installed indoors, you must make

provisions for venting the engine exhaust to the outside of

the building.

engIne OIL CHeCK

To check the engine oil level, make sure the light tower is

placed on secure level ground with the engine stopped.
1. Remove the filler cap/dipstick from its holder and wipe

it clean.

2. Insert and remove the dipstick from its holder. Check

the oil level shown on the dipstick.

3. If the oil level is low, add oil through the oil filler hole. DO

NOT overfill. Fill to the normal operating level as shown

WaRnIng

Ensure adequate ventilation when

operating the light tower in enclosed areas.

The engine exhaust contains noxious

elements.

on the dipstick. Verify that the oil level is maintained

between the two notches as shown in Figure 6. Always

fill with recommended type oil as listed in Table 4. See

Table 2 for engine oil capacity.

Figure 6. Oil Dipstick

Other types of motor oils may be substituted if they meet

the following requirements:

„

API Service Classification CH-4

„

API Service Classification CG-4

„

API Service Classification CF-4

„

ACEA Specification E3

„

ACEA Specification E2

FueL CHeCK

Table 4. Recommended motor Oil

(Lombardini engines)

-40 -35 -30 -25 -20 -15 -10

-5

0

5

10

15

20

25

30

35

40

45

50

-40 -31 -22 -13

-4

5

14

23 32

41

50

59

68

77

86

95 104 113 122

SAE 10W

SAE 20W

SAE 30

SAE 10W-30

SAE 10W-40

SAE 10W-60

SAE 40

°C

°F

CauTIOn

Diesel fuel and its vapors are dangerous

to your health and the surrounding

environment. Avoid skin contact and/or

inhaling fumes.

DO nOT smoke while

refueling.

DO nOT attempt to refuel the

light tower if the engine is hot or running.

Advertising