New Era NE-500 Multi-Phaser Programmable OEM Syringe - Manual (Page 47)

New Era Pump Systems Inc.
www.SyringePump.com
Model NE-500/NE-501 Multi-Phaser™
Publication #1200-02 42 09/18/14
*ADR [ DUAL | RECP | ALTR ] Set Reciprocating, Dual, or Alternating pumping mode
*RESET Resets pump. Clears program memory and resets setup.
------------------------------------------------------------------------------------------------------------------------------
Network Command Burst => <n> <command> * [Network Command Burst]
Communicate with multiple pumps on a pump network simultaneously
Any command preceded by the asterisk symbol ‘*’ bypasses the pump network address and Safe mode.
10.2 RS-232 Pump Network Connector Wiring
RS-232
To Network To Computer
PC Com Port Connectors
25 Pin 9 Pin
3 - Receive 2 - Receive Connect to pump TXD
2 - Transmit 3 - Transmit Connect to pump RCV
9 - Ground 5 - Ground Connect to pump GND
10.3 Accessories
10.3.1 ANA-BOX™
Part #: ADPT-ANABOX, Analog voltage control interface.
Allows the pump to be controlled by a variable voltage source. Allows the Creation of a closed loop system
allowing the NE-1000 to be controlled by an external sensor, such as a pressure sensor, or other variable
voltage source. Start or stop the pump at a specific voltage level. Set the pumping rate to be proportional to
the voltage input.
10.3.2 Syringe Heater
Part#: SYRINGE-HEATER, see www.SyringeHeater.com for details.
Flexible heating pad that wraps around the syringe. Thermo-Kinetic Heat Clamping digital controller will heat
a syringe to a set temperature up to 100 C.
10.3.3 RS-232 Network Cables
RS-232 Network Primary Cable
7 foot cable
Part #: CBL-PC-PUMP-7
25 foot cable Part #: CBL-PC-PUMP-25
Cable to connect a pump, or the first pump in a pump network, to a standard computer’s RS-232 serial port
with a DB-9 connector. A 9 pin to 25 pin converter is available upon request.
RCV from network
TXD to network
TXD to computer
RCV from computer