MacDon D65 SP DHOM - Manual (Page 226)

MAINTENANCE AND SERVICING
6. Tighten clamp (A) with modified channel lock pliers (B)
so that finger pressure will NOT move clamp.
IMPORTANT:
Over-tightening clamp may result in breakage.
Figure 6.186: Clamp Tool
7. Line up tine bar (B) with cam arm and install bolt (A).
Torque bolt to 120 ft·lbf (165 N·m).
Figure 6.187: Cam End
8. At the center disc, install the bolts (A) securing arm (B)
to disc.
9. At the tail end, install reel arm (B) and endshield
support (C) from the tail end of the reel at applicable
tine tube location with bolts (A).
NOTE:
There are no endshields on the center discs.
Figure 6.188: Tail End
169899 214 Revision A