RKI Instruments SD-705EC - Manual (Page 14)

PT2E-1140
２−６ Wiring Method
(1) After installation of detector, confirm that there is no error in installation, and carry
out connection between equipment as follows.
① Connection of the ＳＤ−７０５ＥＣ to the indicating alarm section(ＥＣ−５８３etc.)
CVVS-3C
1.25sq で 1.25km MAX
2.0
sq で 2.0 km MAX
指
ＥＣ-583
SD-70５ＥＣ
DC24V
3
4
5
6
DC24V(シングルケース)
100V(マルチケース)
＋ − Sig
入力電源
AC
DC24V(single case)
AC100V(multi-case)
Power input
示警報部
Indicator
EC-583
MAX 1.25km by 1.25sq.
MAX 2.0km by 2.0sq.
② Connection of ４∼20mA of the ＳＤ−７０５ＥＣ to the ＤＣＳ, etc.（Example）
アイソレータ（必要に応じて）
CVV-2C
中継端子台
＋
C100V
SD-70５ＥＣ
DC24V
＋ − Sig
ＤＣＳ
DC24V
−
＋ −
CVVS-3C
Isolator(if necessary)
DC24V(single case)
AC100V(multi-case)
Relayed terminal
電源 POWER
DC24V
電源入力
A
Power input
AC100V
(２)For safety and to protect an instrument from external noise, be sure to make ground
before power on. Use cable as think and short as possible in order to suppress resistance.
Use internal of instrument or “E” bolt (Refer to Page 5) on the bottom of instrument for
ground.
13