Salsbury Industries 92000 Series Plastic Lockers (92168,92368 Double Tier) - Manual

Plastic Lockers – 92000 Series
Models 92168 & 92368 Double Tier
Assembly Instructions
Thank you for selecting Salsbury 92000 Series Plastic Lockers. We are confident that the quality and construction of the lockers will prove to be a
good investment. These instructions are intended to assist you in the assembly of the lockers. Individual job conditions will dictate whether the
lockers must be anchored to the wall, the floor, or both. Please read the entire assembly instruction document before beginning assembly.
Step 1. Insert the back panel tabs into the pockets along the rear
edge of the side panel. Tap with soft mallet to engage two (2) latch
points.
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 05, 7/22/2010) Page 1 of 4
Step 2. Press another side panel onto the tabs on the other side of
the back panel. Tap to engage as above.
Step 3. Join and press down the sides-and-back-panel assembly
from step 2 above into the base panel as shown below. The base
panel is the thicker of the three (3) horizontal panels provided. Then
thread four (4) leveling feet provided into the bottom of the base
panel.
Step 4. Join two long interlocking plastic joint pieces and one short
interlocking plastic joint piece into a U-shaped assembly as shown
below. Press the U-shape assembly down onto the U-shaped top
edges of the lower (first) unit assembly from step 3.
LOWER
(FIRST)
UNIT
Step 5. Assemble a second unit per Steps 1 and 2. Press this
assembly into the joint assembly on the top of the lower half of the
unit from Step 4 above. Then press down one of the two top panels
(thinner) onto the top of the assembly.
SIDE
PANEL
BACK
PANEL
OTHER
SIDE
PANEL
BASE PANEL
(THICKER)
SHORT
STRIP
LONG
STRIPS
TOP PANEL
(THINNER)
INTERLOCK
INTERLOCKING
JOINT
ASSEMBLY
LOWER HALF
OF THE UNIT
LOWER
(FIRST)
UNIT
LEVELING FEET
(NOT SHOWN)
JOINT ASSEMBLY
LOWER
(FIRST)
UNIT
JOINT
ASSEMBLY