Salsbury Industries 92000 Series Plastic Lockers (92168,92368 Double Tier) User Manual
Page 2
Plastic Lockers – 92000 Series
Models 92168 & 92368 Double Tier
Assembly Instructions
Step 6. If no optional sloping hood is ordered, install the three filler
strips into the recesses in the top of the remaining (second) top
panel.
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering
@
lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 05, 7/22/2010) Page 2 of 4
Step 7. Assemble a second compartment per steps 1 though 5
except without a base panel and using the second top panel with the
filler strips installed. This unit will not have leveling feet. Stack this
second unit onto the first unit as shown below. Use a mallet if
necessary.
Step 8. Install screws and hole covers where side panels join to top
panels and base panel. There are 18 screws and hole covers on
each side of the two sides of the assembly (36 in total).
Step 9. Install a lock catch bar at the center of each of the two (2)
compartments, on the left front inside edge of the side panel with the
four (4) short flathead screws provided.
Step 10. Attach the plastic oval lock plate to the front of the two (2)
doors with two (2) screws from the rear of the door. Insert the
stainless steel hasp through hole in front of doors making sure cutout
is facing downward. Secure by threading nut provided onto it from
rear. Insert lock knob through hasp from front of door making sure
hole in lock knob is facing downward. Attach cam to rear of lock
knob shaft with screw provided. Be sure the cam is pointing toward
the outside of the door and is properly engaged with the square shaft
end of the lock knob.
SECOND
TOP PANEL
(THINNER)
BASE PANEL
(THICKER)
CAM
LOCK
PLATE
HASP
LOCK
KNOB
NUT
FIRST
TOP PANEL
(THINNER)
SECOND
UNIT
FIRST
UNIT
FILLER
STRIPS
FILLER
STRIPS
INSTALLED
LOCK
CATCH BAR
SCREWS (2)
PLACARD
(OPTIONAL)
SCREW
FOUR (4)
SCREWS
BOTH
UNITS
STACKED
COVERS
HOLES
SCREWS