Salsbury Industries 92000 Series Plastic Lockers (92168,92368 Double Tier) - Manual (Page 3)

Plastic Lockers – 92000 Series
Models 92168 & 92368 Double Tier
Assembly Instructions
Step 11. Fasten the eight (8) hinges (four (4) for each of the two (2)
doors) provided in the hardware package securely to each hinge
position with the screws provided as shown below. Fasten each of
the two (2) doors to the appropriate set of hinges.
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 05, 7/22/2010) Page 3 of 4
Step 12. Install coat rods by pressing ends into locating tabs near
top of compartment. Use the locating tabs behind the stiffener rib.
HINGES
COAT ROD
Step 13. Slide the shelves (optional) into the slots in the locker side
panels. There are six (6) slots available for shelves in each of the
two (2) compartments.
SHELF
Step 14. Install the sloping hood (optional) to the top of each locker
column by aligning six (6) locating tabs with the topmost panel.
Press locating tabs into place. Illustration shows sloping hood before
pressing tabs into place. Plastic filler strips shown in Step 6 are not
required on units with a sloping hood and can be discarded.
SLOPING
HOOD