SATEC PTS175 Manual - Manual (Page 2)

PTS175 MV Advanced Analyzer 2
LIMITED WARRANTY
The manufacturer offers the customer a 24-month functional warranty on the instrument for faulty
workmanship or parts from date of dispatch from the distributor. In all cases, this warranty is valid
for 36 months from the date of production. This warranty is on a return to factory basis.
The manufacturer does not accept liability for any damage caused by instrument malfunction. The
manufacturer accepts no responsibility for the suitability of the instrument to the application for
which it was purchased.
Failure to install, set up or operate the instrument according to the instructions herein will void the
warranty.
Only a duly authorized representative of the manufacturer may open your instrument. The unit
should only be opened in a fully anti-static environment. Failure to do so may damage the
electronic components and will void the warranty.
The greatest care has been taken to manufacture and calibrate your instrument. However, these
instructions do not cover all possible contingencies that may arise during installation, operation or
maintenance, and all details and variations of this equipment are not covered by these instructions.
For additional information regarding installation, operation or maintenance of this instrument,
contact the manufacturer or your local representative or distributor.
WARNING
Read the instructions in this manual before performing installation and take note of the
following precautions:
1. Ensure that all incoming AC power and other power sources are turned OFF before performing
any work on the instrument.
2. Before connecting the instrument to the power source, check the labels on the back of the
instrument to ensure that your instrument is equipped with the appropriate power supply
voltage, input voltages and currents. Failure to do so may result in serious or even fatal injury
and/or equipment damage.
3. Under no circumstances should the instrument be connected to a power source if it is
damaged.
4. The instrument must be primarily protected against lightening arrester installed as close of
possible to the POLE top sensors (PTS) located over the lines. The PTS175, HV arresters and
PTS must be properly grounded to the earth.
5. Only qualified personnel familiar with the instrument and its associated electrical equipment
must perform setup procedures.
6. Do not open the instrument under any circumstances when it is connected to a power
source.
7. Do not use the instrument for primary protection functions where failure of the device can
cause fire, injury or death. The instrument can only be used for secondary protection if
needed.
Read this manual thoroughly before connecting the device to the current carrying
circuits. During operation of the device, hazardous voltages are present on input
terminals. Failure to observe precautions can result in serious or even fatal injury or
damage to equipment.
All trademarks are property of their respective owners. Copyright  2007-2013