Package contents, Installation instructions, All sti quickfit – Schroth Racing QuickFit And QuickFit Pro Subaru WRX/STi (2002-2006) User Manual
Page 4
4
PACKAGE CONTENTS
The contents of each package is as detailed in the table
below for each belt.
Subaru STi QuickFit
®
Left
Subaru STi Left Belt
1x
Left side lap belt connector 1x
Left side tail strap connector 1x
7/16“ Bolt
1x
Washer 1x
Spacer 1x
SCHROTH asm sticker
1x
SCHROTH Racing sticker
1x
STi Rallye 4 Install Inst.
1x
Subaru STi QuickFit
®
Right
Subaru STi Right Belt
1x
Right side lap belt connector 1x
Right side tail strap connector 1x
7/16“ Bolt
1x
Washer 1x
Spacer 1x
SCHROTH asm sticker
1x
SCHROTH Racing sticker
1x
STi Rallye 4 Install Inst.
1x
All STi QuickFit
®
belts re-use factory mounting
bolts for the outside mounting points.
MANUFACTURING INFORMATION
Each SCHROTH belt is manufactured to exacting standards.
Specific manufacturing information of each belt is printed on
the back side of the plastic asm cartridge cover.
asm cover
Type of belt
Date of manufacture
Product number
Always keep this manual in the vehicle so that others can
thoroughly familiarize themselves with the proper use of
the system.
INSTALLATION INSTRUCTIONS
1 General
Instructions
Always leave original equipment seat belts in place and
available for use.
We strongly recommend that you leave in place all Subaru
factory provided 3-point restraint systems originally supplied for
the front and rear seating positions of your vehicle when you
install the SCHROTH asm
®
harnessbelt. Removal of original
equipment restraint systems may also violate applicable State
or Federal law.
To carry rear seat passengers, you must use your standard 3-
point factory provided front seat belts. To use the factory
installed seat belts after a SCHROTH Subaru STi QuickFit
®
belt has been installed you must first release (un-clip) all four
points of the SCHROTH belt and remove it.
Leaving original equipment restraint systems in place and fully
functional will enable you to choose either the SCHROTH
QuickFit
®
OR the vehicle’s standard seat belts when it is
necessary to transport passengers in any of the rear seats or
when either harness belt is not suited for use by the driver or
front seat passenger.
When using the SCHROTH harnessbelts, folding front seat
backrests will be restricted in their range of motion.
Evacuation or rescue of rear seat passengers can be
restricted or even impossible after an accident and severe
injuries or death may occur.
DO NOT CARRY REAR SEAT
PASSENGERS WHEN USING SCHROTH RALLYE BELTS.
Separate SCHROTH asm® harnessbelts are supplied for
the left and right sides. The black “asm® cartridge” must
be on the inboard shoulder strap when system is installed
(see illustration). Never install a belt on wrong side of
vehicle. System will not function properly in an accident
and serious injury or death may occur.