Schroth Racing QuickFit And QuickFit Pro Subaru WRX/STi (2002-2006) - Manual (Page 6)

6
4 Removal of Interior pieces for Lap belt connection
installation.
Remove small plastic retaining tab.
Plastic Piece is held in with tension clips
Pull up in a vertical plane to remove.
The B-pillar cover must be removed.
Remove the pin of the expanding rivet and insert.
Slowly pull the plastic cover off of the car.
(the plastic has a fair amount of flex but be gentle)
The carpet must be pulled back. There is
a small clip that holds the carpet in place, slide it forward.
5 Installation of SCHROTH Front outside connector–
Left & Right belts.
Once the carpet is pulled back the mounting point will
be exposed. It is where the factory belt attaches.
(do not use the point where the inertia-real is bolted)
Locate and remove (using a 14mm socket) the
outermost lap belt anchor bolt.
Mount the SCHROTH bracket as shown in the picture
above left. Be sure to use the STi hardware, bolt,
washer, and spacer as pictured above.
Before tightening the bolt, align the Schroth connector
so that the webbing is pulling in the same direction
that the belt will pass over your lap when connected.
Reinstall the carpet allowing the Schroth piece and
factory belt to come out of the pre-cut hole in the
carpet. Reinstall all factory molding and pieces in the
reverse order of disassembly.