SciGene 700 Microarray Oven - Manual (Page 5)

Model 700 Microarray Oven — USER MANUAL
Version 2.1, February 2011 (408) 733-7337, [email protected]
4
II. UNPACKING AND SETTING UP YOUR OVEN
A. Removing the Unit from the Carton
Position the shipping carton on the floor close to the location of
intended installation. Remove the foam inserts from the top of the unit.
Position a person at the front and one at the back of the oven. Grip the
recessed edges along the top of the unit and lift it straight up and out of
the shipping carton taking care to keep it balanced. Place it on the bench
or table where it will be installed.
Carefully inspect the unit for damage. If there is evidence of damage, do
not discard the shipping materials since they may be needed to return
the unit.
B. Parts Provided
The following items are included with the oven. Please note that rotators
are sold separately (see Section VII).
• Power Cord
• User Manual
C. Installation
1. Placement
Place the unit on a stable, level surface within a few feet of the
power source. Avoid locating it below a shelf where solutions are
stored. A spill may enter the electrical compartment through the
vent holes on the top of the unit and cause damage. Ensure there
is adequate clearance along the front and right side of the oven to
open the door completely.
There should be a minimum clearance of 3 inches along the top
and back panels for air circulation.
2. Connecting the Power
Plug the power cord provided into the back of the unit and then to
a properly grounded outlet. Use only the power cord provided.
3. Powering On
Turn power ON to the unit using the switch on the front of the
unit.