STEMCO Axle Pro - Manual (Page 13)

Axle Pro Equipment Instruction Guide
For your protection, use Standard Shop Safety Procedures during this process
Page 13 of 24 01 577 0092 SEPT 2011
Step 5: Alignment Bushing & Drill Placement
a. Place alignment bushing in upper plate hole.
(See photo 5A)
b. Plug magnetic base drill into proper outlet. Using proper
lifting techniques place magnetic based drill onto upper
plate.
Do Not Engage Magnet. Caution must be taken
as the unit is not secure at this time. (Photo 5B)
c. Align cutter into alignment bushing. (See Photo 5C)
Photo 5A
Photo 5B
Photo 5C