STEMCO Axle Pro - Manual (Page 5)

Axle Pro Equipment Instruction Guide
For your protection, use Standard Shop Safety Procedures during this process
Page 5 of 24 01 577 0092 SEPT 2011
TABLE OF CONTENTS
Part list / Photo Glossary-- Pages 6-7
Step 1: Remove, Inspect Components & Attach Mandrels--
Page 8
Step 2: Pre-Drill Cutter & Reamer Setup-- Page 9
Step 3: Axle Alignment Assembly-- Pages 10-11
Step 4: Leveling Bar & Drill Speed Setup-- Page 12
Step 5: Alignment Bushing & Drill Placement-- Page 13
Step 6: Engage Magnet & Assemble Coolant System-- Page 14
Step 7: Drilling Procedure-- Page 15
Step 8: Second Pass Reaming Process-- Page 16
Step 9: Sleeve Installation-- Page 17
Part listing-- Page 18
Kit break downs-- Page 19
Cross-Reference-- Pages 20-21
Bore sizes-- Page 23
Failure to follow the instructions when using the Axle Pro Equipment could create a risk of personal injury to
the servicing technician and/or component damage, which may jeopardize the safety of the vehicle and that
of the operator. Do not install sleeve and/or any other axle parts in an axle that has been improperly drilled
or reamed. Components of the Axle Pro Equipment are for intended use with the Axle Pro Equipment only,
failure to use for intended purpose and/or in the proper manner may result in injury.