STEMCO Axle Pro - Manual (Page 14)

Axle Pro Equipment Instruction Guide
For your protection, use Standard Shop Safety Procedures during this process
Page 14 of 24 01 577 0092 SEPT 2011
Step 6: Engage Magnet & Assemble Coolant System
a. Engage drill magnet. (Photo 6A)
b. Remove alignment bushing prior to cutting axle. (Photo 6B)
c. Assemble the coolant system: Put pump into the bucket.
Add 3 pints of coolant and 3 gallons of water and mix
thoroughly. (Photo 6C)
System comes with 3 pints of
concentrated coolant. Dilute 3 pints of concentrate with 3
gallons of water.
d. Thread coolant hose through notch in bucket. Attach screen.
Place magnetic base manifold on upper plate and align
nozzles over axle eye. (Photo 6D).
Be sure to leave enough
room for cutter clearance to allow coolant to flow without
damage to the nozzles.
Photo 6D
Photo 6A
Photo 6C
Photo 6B