STEMCO Axle Pro - Manual (Page 8)

Axle Pro Equipment Instruction Guide
For your protection, use Standard Shop Safety Procedures during this process
Page 8 of 24 01 577 0092 SEPT 2011
Step 1: Remove & Inspect Components - Attach Mandrels
a. Remove all components including kingpins, steering knuckle
and associated parts using standard shop procedures and
practices. (See Photo 1A)
b. Clean and inspect axle eye. Using a measuring tool
(telescoping gauge and micrometer or STEMCO Kaiser
“go no go gauge”) measure your axle eye size. Determine
correct axle eye size and required cutter. (See Photo 1B)
Refer to Axle Pro Equipment Cross-Reference Matrix Sheet
(page 19 of this book or literature part # 01 577 0093).
c. Attach centering mandrels (Tapered Items) to axle bore top and
bottom using threaded rod and nuts. (See Photo 1C)
d. At the batteries, install an arc suppression tool unit in the
vehicle to avoid magnetic interference or power surges. (See
Photo 1D) (Not included in Kit)
Photo 1A
Photo 1B
Photo 1C
Photo 1D