Summit DW2432SS User Manual - Manual (Page 22)

20
1. Remove the lower rack from the machine.
2. Turn the coarse filter counter-clockwise to the
left and pull it out in an upward direction (A).
3. Pull out the main filter (B).
4. Press on the two tabs of the coarse filter and
remove the micro filter (C).
5. Clean the filters thoroughly under running
water. Use a brush if necessary.
6. Replace main filter.
7. Replace the micro filter and the coarse filter
into the main filter.
8. Twist it clockwise until it clicks into place.
CAUTION
Do not operate your dishwasher without a
filter. You will damage your machine. Ensure
that your filters are correctly installed.
10.2.2 CLEANING THE SPRAY ARMS
Notice:
Dirt and/or calcium residue may block the
nozzles on the spray arms. For this reason,
regularly check the spray nozzles.
1. Lower spray arm
2. Upper spray arm
1. Remove the lower rack from the machine.
2. Pull off the lower spray arm with an upward
direction (A).
3. Loosen the fastening screw of the upper spray
arm and pull off the spray arm (B) with a
downward motion.
4. Clean the spray arms under running water.
5. Replace the lower spray arm with a downward
motion.
6. Replace the upper spray arm and tighten the
fastening screw by turning it around to the left.
7. Insert the lower rack.
CAUTION
Ensure that the fastening screw is tight on
the upper spray arm.