Sunnex TS2015W (Wall) - Manual (Page 10)

Sunnex Tristar Service & Installation Manual 10
CAUTION: ONLY USE OSRAM/SYLVANIA TRU-AIM TITAN BULBS, ANY
DEVIATION FROM THE DIRECTIONS MAY SERIOUSLY DAMAGE YOUR
LIGHT. 35W IS MAXIMUM ALLOWED.
When a lamp/reflector burns out, ALLOW SUFFICIENT TIME FOR IT TO
COOL BEFORE ATTEMPTING A REPLACEMENT. Once cool, you should:
1. Refer to figure. Turn the lamp head over so the three glass
assemblies face upward.
2. With one hand supporting the backside of the lamp, grasp the
notched ring assembly (1) and twist it counter clockwise.
3. Grasp the bulb with one hand and unplug socket connector with the
other.
4. The notched ring assembly may now be removed from the lamp head
and placed face down on a flat surface.
5. Hold the notched ring assembly with thumbs and place two index
fingers at flat part of spring (two red lines in figure 8), pull the spring
towards you pulling it out from the slot (Keep two ends of spring inside
it’s holes)
6. Remove old bulb
7. Install new bulb. Do not touch inside reflector surface of bulb, always
grasp from bulb outside edges
8. Close the retainer spring on the bulb by inserting the front tab of
spring in the slot (using index fingers), so that it fits properly. Check to
ensure proper seating of the spring, by pulling on the bulb. [Position
(1) in figure 8 is “CLOSED SPRING”]. Ensure that two open ends of
spring are properly seated into holes in the notched ring assembly.
9. Reconnect plug socket to bulb.
10. Replace the notched ring assembly in the lamp head by aligning the
three guide projections into the slots on the lamp head. Refer to figure
9. Press gently inward as you twist the assembly clockwise. You will
hit a stop and set in place. Before turning the lamp head over, BE
POSITIVE THE ASSEMBLY IS PROPERLY SEATED by comparing it
with the other two.
PUSH HERE
TO REMOVE