Sunnex TS2015W (Wall) - Manual (Page 7)

Sunnex Tristar Service & Installation Manual 7
2. Raise the metal QUIK-CONNECT collar at the base of the DUAL/FLEX
arm, and slip the assembly onto the standoff on top of the wall
extension arm. Once in place, push down on the collar to properly seat
the connection. CAUTION! IF YOU DO NOT EITHER HEAR IT SNAP
INTO PLACE OR FEEL A POSITIVE SEATING, PROPER
CONNECTION HAS NOT BEEN ACCOMPLISHED. CHECK AGAIN
TO ENSURE YOU HAVE SECURELY CONNECTED THE LAMP
HEAD/ARM ASSEMBLY TO THE STANDOFF.
3. Fix the lamp head arm cord to the under surface of the arms with the
furnished plastic fasteners.
4. Plug the lamp head cord into the outlet in the transformer enclosure.
5. Plug the three-prong power cord from the transformer enclosure into
the wall outlet.
6. ABOUT YOUR TRISTAR
TRISTAR LAMP HEAD: The lamp head is constructed of high impact
polycarbonate, which offers certain protection not available with metal
reflector lights. The covers and frame provide a safeguard to the reflectors
encased within their design. Along with good physical and thermal qualities,
polycarbonates offer the added advantage of presenting a level of protection
against possible current leakage. The reward is a lack of heat build-up that is
normally experienced with metal reflectors, thus eliminating the danger of
contact burns from a hot reflector surface.
The lamp head rotates 359 degrees in either direction at the point at which it
attaches to the DUAL/FLEX, vinyl coated arm. The control of its movement is
via the handles built into the lamp head frame. The TRISTAR lamp head has
been designed to accept a Sterilizable handle. Should you desire this option,
order a STERILIZABLE HANDLE & MOUNT ASSEMBLY, COMPLETE, P/N
STHM-2.
WASHER