Traditions Vortek StrikerFire - Manual (Page 29)

29
TRADITIONS™ FULL BORE BULLETS:
Note: Full Bore bullets do not require any lube for loading.
1. Place the projectile into the barrel using the ball starter and ramrod.
Follow the same procedures as shown with the saboted bullet loading
described previously.
Note: Patches are not to be used with Full Bore bullets; these
bullets are made to full bore size.
It is critical that the Full Bore bullet is the correct size to your bore. It
must fit fairly tight and require moderate pressure to seat on top of the
powder. A loose fit could cause the projectile to separate from the
powder, particularly if the gun is subjected to jarring or sharp
movement before ignition.
CONICAL BULLETS:
Note: When using conical bullets or patched round ball, it is
recommended to use loose powder only.
1. Lubricate the projectile with Wonderlube™ 1000 Plus.
2. Place the projectile into the barrel using the ball starter and ramrod.
Follow the same procedures as shown with the saboted bullet loading
described previously.
Note: Patches are not to be used with conical bullets; these
bullets are made to full bore size.
It is critical that the conical bullet is the correct size to your bore. It
must fit fairly tight and require moderate pressure to seat on top of the
powder. A loose fit could cause the projectile to separate from the
powder, particularly if the gun is subjected to jarring or sharp
movement before ignition.