Unisteer 8011940-01 Mercury Cougar Power Rack 1967-70 - Manual (Page 11)

Page 11 656790
3. From under the car remove the gear box and shaft assembly, (all one piece.)
4. Place your column tube on a flat surface and measure from the very bottom of the column towards
the steering wheel 3- 1/8”. Mark the column check the measurement again and cut the tube off
squarely at you mark. Next install the supplied column bearing into the bottom of the tube by tapping
it into place with a hammer.
5. Once you have this done install the appropriate floor plate provided in your kit using the hardware
provided. Slide the floor plate over the column tube with the clamp and install the column through the
firewall and bolt back in place. Attach the new floor plate with supplied hardware and complete the
installation.