Unisteer 8010700-02 Chevrolet Chevelle Power Rack & Pinion Kit 1968-72 - Manual (Page 2)

pg. 2
655620
Kit Contents:
# Part Number Description Quantity
1 8010690-01 Rack & Pinion Assembly 1
2 8021940 Mounting Bracket 1
3 8020940 Outer Ends 2
4 270360 Ball Center Bracket 1
5 241570 End Cap 1
6 231580 ½-20 x 4 ½” Socket Head 2
7 231520 3/8- 16 x 1” Button Head Cap 4
8 208000 3/8” Star Washer 4
9 206080 Spacer Washer 2
10 206040 Spacer Washer Bellow 2
11 206030 Ball Center Stand Off 1
12 140780 Bellows 2
13 621710 Banjo Kit (16mm & 18mm) 1
14 231530 7/16-14 x 4 ½” Hex Bolt 2
15 231490 3/8”-16 x 1 ½” Hex Bolt 2
16 200860 7/16” Flat Washer 4
17 200850 5/16” Flat Washer 4
18 120490 3/8”-16 Lock Nut 2
19 120410 Jam Nut 2
Disassembly:
1. Disconnect negative battery cable before installation.
2. Raise front of vehicle off ground & center & lock steering wheel.
3. Remove front wheels & remove power-steering lines at pump or gearbox.
4. Drain fluid.
5. From under hood, remove pinch bolt at gearbox & shaft union & separate.