Unisteer 8010700-02 Chevrolet Chevelle Power Rack & Pinion Kit 1968-72 - Manual (Page 5)

pg. 5
655620
6. Tighten outer tie rod ends to 35 ft. lbs.
7. Install power steering pressure line smaller line to lower port on rack assembly and tighten.
8. Install return line to upper port larger line to rack assembly & tighten.
9. Make sure lines are pointing toward front of car & route lines upward towards pump. Note:
Make sure lines do not interfere with pulleys, belts, etc.
Shaft Installation:
1. Install column joint end onto stock steering shaft & tighten. Note: On big block cars it is
necessary to slide shaft under header tube to clear & attach to column shaft.
2. Install heim joint into threaded hole of column support bracket so about five threads are
showing. Install jam nut on bracket. (see following page for picture) DO NOT TIGHTEN!
3. Please assemble your steering shaft assembly as shown below:
4. Slide lower shaft through heim joint & install bracket over the driver side from bolts &
mounting bracket.