Unisteer 8010700-02 Chevrolet Chevelle Power Rack & Pinion Kit 1968-72 - Manual (Page 4)

pg. 4
655620
11. From under hood, remove nut & bolt assembly from steering shaft at firewall and remove
stock steering shaft. Note: You may need to spread clamp or tap off. Note: Do not use
excessive force. You must not damage bearing in column.
12. Remove four bolts retaining stabilizer bar mount bushing & let stabilizer hang free from links.
Installation:
1. Your rack & pinion has been shipped to you assembled & screwed to the mounting bracket.
Do Not Remove Rack & Pinion from Bracket.
2. Pull down on stabilizer bar & install racket bracket from over top of the bar. Note: Make sure
you install the assembly with tie rods on underside of stabilizer.
3. Slide bolts through drive-side frame & through bracket.
4. Slide bolts through passenger side frame into bracket & start nuts. Leave loose.
5. Connect outer tie rods to steering knuckle & adjust the rods by eye to keep front wheels
straight.