Unisteer, Performance products – Unisteer 8010700-02 Chevrolet Chevelle Power Rack & Pinion Kit 1968-72 User Manual
Page 7
pg. 7
655620
2. It may be necessary to measure & purchase a new belt for pump assembly.
3. Your other pump bracket attaches to front of cylinder head. Adjust your belt tension &
tighten to 25lbs.
4. Install pressure line to pressure port on pump and tighten.
5. Install your return line to port on reservoir connection and tighten clamp.
6. Top off power steering fluid and start car.
7. Check for leaks right away. If ok, turn wheels all the way right to left and hold for three
seconds. This will bleed air from the system.
8. After air is bled, top off fluid & install cap.
9. Your vehicle will need an alignment to reset your toe adjustment. It is best to see a pro
with the proper aligning equipment.
Alignment Specs:
Toe: 1/8 TOTAL (1/16 EACH SIDE)
Camber: ½ DEGREE NEGATIVE
Caster: 1 DEGREE POSITIVE +/- ½
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised on 6/13/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording or by any information storage
and retrieval system, without permission in writing from Maval Manufacturing Corporation.