Programming modes/feature select – Unisteer Ididit Keyless Ignition User Manual
Page 20
19
PROGRAmmING mODES/FEAtURE SELECt:
Feature Selection mode
The KEY TO KEYLESS has a variety of selectable features to allow you to
customize the systems operation to your individual needs: In the Feature
Chart below, selectable features options are listed in the “Feature Column”.
Feature selection is made by setting the features “Position” to 1, 2 or 3.
To enter
Feature Select mode, first put system in Accessory mode, by
pressing the start button one time without putting your foot on the brake.
Next, then press the programming Button 5 times. The LED should begin
flashing fast then turn ON solid.
Next, push the programming button the number of times equal to the
feature you want to select
(Example: Push 4 times = Feature #4) the LED will flash back confirmation
flashes the same number (4 times)
Next the LED will let you know what “Position” it is currently in by flashing
either 1, 2 or 3 times
(All Features are by default set to #1)
To change the Features position setting; simply push and hold down the
programming button for 1 second then release it. This will advance the
feature to its next position. The LED will flash the corresponding number
of times of the features new position. Pushing and holding again will return
the feature to the original position.
when the selected feature indicates it in the desired position, momentarily
depress the Brake.
The Start Buttons LED will begin flashing fast indicating the selection has
been memorized, then the LED will return to solid ON awaiting the next
feature selection. Change whichever features you desire in any order.
FEAtURE
POSItION 1
POSItION 2
POSItION 3
1.
N/A
N/A
N/A
N/A
2.
N/A
N/A
N/A
N/A
3.
N/A
N/A
N/A
N/A
4.
Start Button LED
OFF when
Armed
Flashing at
Armed
N/A
5. AUX Output/Ch #4
Latched
Momentary
N/A