Unisteer Ididit Keyless Ignition - Manual (Page 5)

4
tHE StARt BUttON:
Generally mounted in the vehicle dash or
center console, the “Start Button” provides
one touch operation of your vehicles ignition
system. Designed to mimic a natural “starting
feel”. The starter will continue to crank as long
as the Start Button is depressed. If you fail to
start your vehicle during the first crank you may
need to push the start button twice to re-initiate
the “Crank” mode.
tHE IGNItION CONtROL mODULE (ICM):
ImPORtANt Always mount the ICm inside of your vehicle, DO NOt
mount in the engine compartment!
The KEy tO KEyLESS ICm
provides two functions. It
contains the systems receiver
and reader components that
handle communication between
your vehicle and the Key FOB.
Secondly, the
ICm houses a group
of high current 60 AMP Relays that
provide all switching operations for
the Ignition, Accessory and Starter circuits. By bringing all the system relays
on board K
EY TO KEYLESS eliminates the “spaghetti look” of hand wiring
multiple external relays.
All wires are professionally terminated using Molex® high current connectors
that plug and lock securely to the ICM. Independent switching of accessories
allows KEY TO KEYLESS to be configured in several different ways: One
Accessory circuit can be turned
OFF during starter “crank” to reduce battery
load while your Ignition circuit stays ON.
(Illuminated Push Button in-
stalled in ididit’s Tilt Column)
(ididit’s ICM)