Unisteer 8010920-01 Late 1967-70 Mustang Rack Kit - Manual (Page 13)

Page 13 655650
7. Next you need to cut off the inner tube of the steering column tube. This is the tube
that has the lever on it. Cut it off as close to the steering column tube as you can. DO
NOT CUT THE ACTUAL STEERING COLUMN TUBE. When cutting the inside
tube be sure to only cut the tube itself and not the inside steering shaft. You can
accomplish this by going around the tube with your saw.
8. Once you have cut the inside piece off remove it from the column by sliding it off the
end you cut the rag joint off of.
9. Next take a brass or a drift and tap the inner tube into the steering column tube.
Note: this piece is collapsible. Tap it in about 1” This will allow the clearance
needed to install the bearing.
10. Once that is complete you need to make sure the steering shaft itself is clean and free
of burs. Install the supplied bearing over the steering shaft and tap it into the column
tube by walking it in with a small hammer.